Essays on College Pro

College Pro To: Jon Paggett From: Russell Phillips Date: 10/12/00 Re: virulence scrutiny Purpose Possibility of using hardness exam as a way to determine the amount of preserve coil in our 60-40 brass sheets Procedure We started with a sweat on forefend, where we determined the dimensions using a dial measure and calculated the hardness using a hardness tester. We then stone- gelid-rolled the bar in small(a) increments using a rolling mill, victorious the same measurements after we had completed approximately 5% cold ply. All of this data is on the attached sheet.

Results Results were as anticipate ? Hardness appeared to generally increase as cold work was done (see attached graph). There was a small defect in the experiment, the hardness does seem to decrease at active 15% - this is probably due to measurement geological fault as the general trend should be valid passim the experiment. result My view on the situation is that we should not interchange our procedures at this poin...If you want to get a full essay, regularise it on our website: OrderCustomPaper.com

If you want to get a full essay, visit our page: write my paper